C0562 code meaning
Brake Pedal Position Sensor Supply Voltage Circuit/Open
What C0562 means
Hybrids, EVs and brake-by-wire cars measure how hard the driver wants to brake with a contactless pedal angle or travel sensor. Bosch builds these with a magnetic field sensor on a 5 V supply and two redundant outputs, often pulse-width modulated, so the module can cross-check them. C0562 reports that this 5 V feed is interrupted – the module sees no usable supply at all, unlike C056D (too low) and C056E (too high). No maker publishes a C0562 threshold; Ford's hybrids watch the same supply for a window of 4.87–5.13 V over 50 ms. Without the sensor the module cannot split braking between regeneration and friction, so regenerative braking and some assist functions are lost.
C0562 at a glance
- Check engine lightUsually not
- Emissions testNot an emissions code
- Limp modePossible
- Repair difficultyMedium
- Typical labor0.5 to 2 hours
- Clears after repairWhen cleared with a scanner
Symptoms of C0562
- Brake system or ABS warning lamp
- Regenerative braking reduced or off, pedal feel changes
- Brake lights or cruise control affected on some cars
Common causes of C0562
- Most likelyBroken 5 V supply wire or pin pushed out at the pedal sensor
- PossibleSensor connector loose or left unplugged after pedal-area work
- PossibleInternal open circuit in the pedal sensor
- Less likelyBrake module no longer providing the 5 V reference
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Brake pedal position sensorSensor supply
What each part of C0562 means
| C | Chassis system: brakes, ABS, steering and suspension. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 62 | The exact fault in that area. |
What to do next
- Note C0562 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about C0562
What does C0562 mean?
C0562 means "Brake Pedal Position Sensor Supply Voltage Circuit/Open". Hybrids, EVs and brake-by-wire cars measure how hard the driver wants to brake with a contactless pedal angle or travel sensor. It is a generic code, so it means the same on every make.
Is it safe to drive with C0562?
Drive gently and only to a workshop. With C0562 the car can go into limp mode (reduced power) to protect itself.
Will C0562 fail an emissions test?
C0562 is not an emissions code, so on its own it usually does not fail an emissions test. Other stored codes or a lit check engine light still can.
How hard is C0562 to fix?
Difficulty: medium. A typical repair takes 0.5 to 2 hours of work. This is a job for a workshop.
Will C0562 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.