P0082 code meaning
Intake Valve Control Solenoid Circuit Low Bank 2
Powertrain system Generic code P00xx codes Check engine light
What P0082 means
A solenoid valve on the cylinder head controls oil flow for the variable valve control on the intake side of bank 2. Depending on the manufacturer it drives a camshaft phaser (for example on Nissan engines) or a valve lift changeover (for example on Subaru engines). This code family reports electrical faults in its control circuit; P0082 means the voltage in the control circuit is too low, typically a short to ground; depending on the driver stage an open solenoid winding can also set this code. Other manufacturers report the same valve under the "camshaft position actuator" codes instead. Valve control is then switched off or stays in its base position. Bank 2 exists only on V and boxer engines.
P0082 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyMedium, DIY possible
- Typical labor0.5 to 1.5 hours
- Clears after repairAfter a drive cycle
Symptoms of P0082
- Check engine light on
- Less power, especially at high engine speed with lift changeover
- Rough idle possible
- Follow-up codes for camshaft timing or misfire possible
Common causes of P0082
- Most likelyControl wire shorted to ground, or solenoid winding open (driver-dependent)
- PossibleShorted turns in the solenoid coil
- PossibleCorroded or oil-soaked connector
- Less likelyOutput driver or supply in the engine control module faulty
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Valve control solenoid intake bank2Valve control solenoid wiringEngine control module
What each part of P0082 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 0 | Area: fuel and air metering and auxiliary emission controls. |
| 82 | The exact fault in that area. |
What to do next
- Note P0082 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0082
What does P0082 mean?
P0082 means "Intake Valve Control Solenoid Circuit Low Bank 2". A solenoid valve on the cylinder head controls oil flow for the variable valve control on the intake side of bank 2. It is a generic code, so it means the same on every make.
Is it safe to drive with P0082?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P0082 fail an emissions test?
Yes, it can. P0082 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P0082 to fix?
Difficulty: medium. A typical repair takes 0.5 to 1.5 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P0082 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.