P0162 code meaning
O2 Sensor Circuit Bank 2 Sensor 3
Powertrain system Generic code P01xx codes Check engine light
What P0162 means
Sensor 3 on bank 2 is a switching oxygen sensor behind a second converter or converter brick. It is rare – documented for Jaguar Land Rover's supercharged V6 and V8 (2013–2016), where it is the 'post-cat' sensor of the second bank, and for Ford systems that monitor part of the converter volume. P0162 is the general circuit code of this sensor, the counterpart of P0142. Jaguar Land Rover assigns the code to that sensor and names software (fixed by reconfiguring the engine module) and water-induced thermal shock as causes; no thresholds are published for sensor 3, so the logic follows the sensor 2 checks. The previous obdex titles from P0162 to P0165 were shifted by one position; P0162 had carried the heater title of P0161. When it fails, the downstream evaluation of that converter is suspended; there is no limp mode.
P0162 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyEasy, DIY possible
- Typical labor0.3 to 1.5 hours
- Clears after repairAfter a drive cycle
Symptoms of P0162
- Check engine light on (usually after two drive cycles)
- Catalyst readiness incomplete
- Usually no noticeable change in driving
Common causes of P0162
- Most likelySensor faulty or damaged by thermal shock
- PossibleWiring or connector under the car damaged
- PossibleEngine module software (Jaguar Land Rover)
- Less likelyExhaust leak ahead of the sensor
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Oxygen sensor bank2 sensor3Oxygen sensor wiringCatalytic converter
What each part of P0162 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 1 | Area: fuel and air metering. |
| 62 | The exact fault in that area. |
What to do next
- Note P0162 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0162
What does P0162 mean?
P0162 means "O2 Sensor Circuit Bank 2 Sensor 3". Sensor 3 on bank 2 is a switching oxygen sensor behind a second converter or converter brick. It is a generic code, so it means the same on every make.
Is it safe to drive with P0162?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P0162 fail an emissions test?
Yes, it can. P0162 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P0162 to fix?
Difficulty: easy. A typical repair takes 0.3 to 1.5 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P0162 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.