P01B0 code meaning
Alternative Fuel Tank A Level Sensor Range/Performance
Powertrain system Generic code P01xx codes Check engine light
What P01B0 means
These codes only apply to vehicles with a gaseous alternative fuel – compressed natural gas (CNG) or LPG – as bi-fuel models alongside gasoline or as dedicated gas engines; on bi-fuel vehicles a fault usually blocks gas operation and the vehicle runs on gasoline. Tank level sensor A only exists where there is a real sender – typically LPG tanks with a float whose position is transmitted magnetically through the tank wall (Roush propane systems: 0.1–4.9 V). With CNG the 'level' is a calculated value. The documented systems report level faults under the gasoline fuel level codes (Roush propane P0460–P0463, GM CNG van P0463), so no manufacturer document using exactly this code was found. P01B0 is the plausibility fault: the level signal is valid but does not fit consumption or refuelling – for example a float that sticks.
P01B0 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyMedium
- Typical labor0.5 to 3 hours
- Clears after repairAfter a drive cycle
Symptoms of P01B0
- Check engine light on
- Gas level display wrong, jumping or empty
- Range or refuelling information unreliable
Common causes of P01B0
- Most likelyFloat or sender mechanism sticking
- PossibleContact resistance in connector or wiring
- PossibleLevel sender faulty
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Alternative fuel tank level sensorSensor wiring
What each part of P01B0 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 1 | Area: fuel and air metering. |
| B0 | The exact fault in that area. |
What to do next
- Note P01B0 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P01B0
What does P01B0 mean?
P01B0 means "Alternative Fuel Tank A Level Sensor Range/Performance". These codes only apply to vehicles with a gaseous alternative fuel – compressed natural gas (CNG) or LPG – as bi-fuel models alongside gasoline or as dedicated gas engines; on bi-fuel vehicles a fault usually blocks gas operation and the vehicle runs on gasoline. It is a generic code, so it means the same on every make.
Is it safe to drive with P01B0?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P01B0 fail an emissions test?
Yes, it can. P01B0 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P01B0 to fix?
Difficulty: medium. A typical repair takes 0.5 to 3 hours of work. This is a job for a workshop.
Will P01B0 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.