P01F2 code meaning
O2 Sensor Circuit Low Voltage Bank 1 Sensor 4
Powertrain system Generic code P01xx codes Check engine light
What P01F2 means
Sensor 4 on bank 1 is a fourth oxygen sensor, behind a third converter or converter brick. The OBD standard provides for up to four sensors per bank, and the code standard defines sensor 4 for bank 1 only. No manufacturer or vehicle using these codes could be identified; the description rests on CARB's requirements for downstream oxygen sensors and the logic of sensors 2 and 3. A switching sensor delivers about 0.1–0.9 V. P01F2 means the signal stays near 0 V – typically a signal wire shorted to ground, a faulty sensor or an exhaust leak ahead of it; GM checks its other downstream sensors for a signal below about 40–60 mV.
P01F2 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyEasy, DIY possible
- Typical labor0.3 to 1.5 hours
- Clears after repairAfter a drive cycle
Symptoms of P01F2
- Check engine light on (usually after two drive cycles)
- Catalyst monitor readiness possibly not set
- Usually no change in driving
Common causes of P01F2
- Most likelySignal wire shorted to ground
- PossibleSensor faulty
- PossibleExhaust leak ahead of the sensor
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Oxygen sensor bank1 sensor4Oxygen sensor wiringCatalytic converter
What each part of P01F2 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 1 | Area: fuel and air metering. |
| F2 | The exact fault in that area. |
What to do next
- Note P01F2 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P01F2
What does P01F2 mean?
P01F2 means "O2 Sensor Circuit Low Voltage Bank 1 Sensor 4". Sensor 4 on bank 1 is a fourth oxygen sensor, behind a third converter or converter brick. It is a generic code, so it means the same on every make.
Is it safe to drive with P01F2?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P01F2 fail an emissions test?
Yes, it can. P01F2 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P01F2 to fix?
Difficulty: easy. A typical repair takes 0.3 to 1.5 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P01F2 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.