P01FD code meaning
Turbocharger Outlet Pressure Sensor B Circuit High
Powertrain system Generic code P01xx codes Check engine light
What P01FD means
Turbocharger outlet pressure sensor B is a second pressure sensor at a compressor outlet – for example one per turbo on twin-turbo engines or a second measuring point; sensor A has the codes P00F8–P00FC. It is a separate family from the boost pressure sensor: GM and Ford report the pressure ahead of the throttle under the boost sensor codes P0236–P0238. No manufacturer using the sensor B codes was found; FCA documents sensor A and a second outlet sensor. P01FD means the signal voltage stays above its upper limit – typically an open signal or sensor ground (the input is pulled up) or a short to voltage. For comparison, GM sets its boost sensor high code above 86 % of 5 V, Ford above 4.88 V.
P01FD at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium, DIY possible
- Typical labor0.3 to 1.5 hours
- Clears after repairAfter a drive cycle
Symptoms of P01FD
- Check engine light on
- Loss of power, boost limited
- Limp mode possible
Common causes of P01FD
- Most likelySensor ground or signal wire open
- PossibleSignal shorted to 5 V or battery voltage
- PossibleSensor faulty
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Turbocharger outlet pressure sensor bSensor wiringEngine control module
What each part of P01FD means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 1 | Area: fuel and air metering. |
| FD | The exact fault in that area. |
What to do next
- Note P01FD and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P01FD
What does P01FD mean?
P01FD means "Turbocharger Outlet Pressure Sensor B Circuit High". Turbocharger outlet pressure sensor B is a second pressure sensor at a compressor outlet – for example one per turbo on twin-turbo engines or a second measuring point; sensor A has the codes P00F8–P00FC. It is a generic code, so it means the same on every make.
Is it safe to drive with P01FD?
Drive gently and only to a workshop. With P01FD the car can go into limp mode (reduced power) to protect itself.
Will P01FD fail an emissions test?
Yes, it can. P01FD is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P01FD to fix?
Difficulty: medium. A typical repair takes 0.3 to 1.5 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P01FD clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.