P024E code meaning
Charge Air Cooler Bypass Position Sensor A Circuit Low
Powertrain system Generic code P02xx codes Check engine light
What P024E means
The charge air cooler bypass is a flap or valve that routes compressed air around the charge air cooler, so the engine and exhaust warm up faster after a cold start; when warm it closes or opens partly to control intake air temperature. It is driven by an electric motor with a built-in position sensor or by a solenoid and vacuum can. Its position sensor is usually built into the actuator, with a 5 V reference and a ratiometric signal. P024E means the signal is below its lower limit – a signal wire shorted to ground or an open signal or 5 V reference wire. Bypass control is then switched off and the flap stays in its rest position. No manufacturer document using this code was found – GM and Ford do not use the bypass codes; the description rests on CARB's component monitoring requirement and a Bosch patent on the bypass valve.
P024E at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyMedium, DIY possible
- Typical labor0.5 to 2 hours
- Clears after repairAfter a drive cycle
Symptoms of P024E
- Check engine light on
- Depending on the rest position: longer warm-up or higher charge air temperature with slight loss of power
- Often nothing noticeable while driving
Common causes of P024E
- Most likelySignal wire shorted to ground or open
- Possible5 V reference missing
- PossibleSensor faulty
- PossibleConnector corroded
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Charge air cooler bypass position sensor aCharge air cooler bypass actuator aSensor wiring
What each part of P024E means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 2 | Area: fuel and air metering (injector circuit). |
| 4E | The exact fault in that area. |
What to do next
- Note P024E and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P024E
What does P024E mean?
P024E means "Charge Air Cooler Bypass Position Sensor A Circuit Low". The charge air cooler bypass is a flap or valve that routes compressed air around the charge air cooler, so the engine and exhaust warm up faster after a cold start; when warm it closes or opens partly to control intake air temperature. It is a generic code, so it means the same on every make.
Is it safe to drive with P024E?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P024E fail an emissions test?
Yes, it can. P024E is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P024E to fix?
Difficulty: medium. A typical repair takes 0.5 to 2 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P024E clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.