P02BE code meaning
Cylinder 10 - Fuel Trim at Max Limit
Powertrain system Generic code P02xx codes Check engine light
What P02BE means
These codes belong to an individual-cylinder fuel correction: a diesel's cylinder balance control measures each cylinder's crankshaft acceleration and adjusts its injection quantity; on gasoline engines a cylinder-selective mixture control does the same. CARB requires the system to report when such a correction has used up its range or one cylinder causes an imbalance. P02BE means the correction for cylinder 10 is at its upper limit: the module keeps giving this cylinder more fuel and still cannot even it out – a sign that the cylinder receives too little fuel or builds too little pressure. Cylinder 10 only exists on engines with ten or more cylinders. GM and Ford use other codes for this (P0263 ff, P219A ff); no manufacturer document describing this code with thresholds was found, so the description follows CARB and published patents.
P02BE at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyMedium
- Typical labor1 to 4 hours
- Clears after repairAfter a drive cycle
Symptoms of P02BE
- Check engine light on
- Rough idle, vibration
- Lack of power, possibly misfire
Common causes of P02BE
- Most likelyInjector of cylinder 10 coked or partly clogged
- PossibleCompression loss in this cylinder (valve, rings, leak at injector or glow plug)
- PossibleInjector circuit high-resistance or connector
- PossibleGasoline: false air at this cylinder's intake (manifold gasket)
- Less likelyInjector correction code missing or wrong after replacement
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Fuel injector cylinder 10Crankshaft position sensorEngine control module
What each part of P02BE means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 2 | Area: fuel and air metering (injector circuit). |
| BE | The exact fault in that area. |
What to do next
- Note P02BE and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P02BE
What does P02BE mean?
P02BE means "Cylinder 10 - Fuel Trim at Max Limit". These codes belong to an individual-cylinder fuel correction: a diesel's cylinder balance control measures each cylinder's crankshaft acceleration and adjusts its injection quantity; on gasoline engines a cylinder-selective mixture control does the same. It is a generic code, so it means the same on every make.
Is it safe to drive with P02BE?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P02BE fail an emissions test?
Yes, it can. P02BE is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P02BE to fix?
Difficulty: medium. A typical repair takes 1 to 4 hours of work. This is a job for a workshop.
Will P02BE clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.