P02DE code meaning
Cylinder 10 Fuel Injector A Offset Learning At Min Limit
Powertrain system Generic code P02xx codes Check engine light
What P02DE means
The engine module learns a small-quantity correction for each injector: on deceleration it gives one injector a tiny test injection (GM about 1.5 mm³), measures the resulting crankshaft acceleration and corrects the injector's activation time per rail pressure step. P02DE means the learned correction for cylinder 10 has reached its lower limit at at least one pressure step: the injector needs much less activation time than nominal – it delivers too much at small quantities or opens early. Cylinder 10 exists only on ten-cylinder engines; no manufacturer using this code was found, so the description follows CARB and the documented codes for cylinders 1–8. It differs from P01DE (over advanced), which some systems derive from the same learning.
P02DE at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyHard
- Typical labor0.5 to 4 hours
- Clears after repairAfter a drive cycle
Symptoms of P02DE
- Check engine light on
- Often nothing noticeable; possibly rough idle or knocking
- Possibly smoke or higher consumption
Common causes of P02DE
- Most likelyInjector of cylinder 10 leaking or over-delivering at small quantities
- PossibleEngine software (update available for some models)
- PossibleInjector correction code not or wrongly programmed after replacement
- Less likelyDisturbed crankshaft signal (worn drive belt, tone wheel, dual-mass flywheel)
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Fuel injector cylinder 10Crankshaft position sensorEngine control module
What each part of P02DE means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 2 | Area: fuel and air metering (injector circuit). |
| DE | The exact fault in that area. |
What to do next
- Note P02DE and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P02DE
What does P02DE mean?
P02DE means "Cylinder 10 Fuel Injector A Offset Learning At Min Limit". The engine module learns a small-quantity correction for each injector: on deceleration it gives one injector a tiny test injection (GM about 1.5 mm³), measures the resulting crankshaft acceleration and corrects the injector's activation time per rail pressure step. It is a generic code, so it means the same on every make.
Is it safe to drive with P02DE?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P02DE fail an emissions test?
Yes, it can. P02DE is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P02DE to fix?
Difficulty: hard. A typical repair takes 0.5 to 4 hours of work. This is a job for a workshop.
Will P02DE clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.