P031D code meaning
Ignition D Control Signal Circuit/Open
Powertrain system Generic code P03xx codes Check engine light
What P031D means
Ignition D is one of the control signal lines from the engine module to an ignition module, ignition output stage or group of coils; which cylinders it serves is defined by the manufacturer, not by the code standard. The code concerns the logic-level control signal, not the coil's primary current (that has its own codes, P0351 ff and P2300 ff). P031D means the control line is open – the module sees a voltage with its driver off that indicates high resistance. No manufacturer using these codes was found; GM reports coil control faults as P0351 ff (open above 30 kΩ, first trip), so the description follows CARB and that analogy. The affected coils fire wrongly or not at all, causing misfire; many modules then shut off injection to those cylinders to protect the catalyst.
P031D at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium, DIY possible
- Typical labor0.5 to 2.5 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P031D
- Check engine light on
- Misfire, jerking, rough idle
- Loss of power, possibly cylinders shut off
- Additional misfire codes P0300 ff
Common causes of P031D
- Most likelyControl line or connector pin open (corrosion, pushed-back pin)
- PossibleIgnition module or coil with integrated driver of this group faulty
- PossibleSupply or ground of the ignition module faulty
- Less likelyDriver stage in the engine module
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Ignition control dIgnition moduleIgnition wiring
What each part of P031D means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 3 | Area: ignition system or misfire. |
| 1D | The exact fault in that area. |
What to do next
- Note P031D and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P031D
What does P031D mean?
P031D means "Ignition D Control Signal Circuit/Open". Ignition D is one of the control signal lines from the engine module to an ignition module, ignition output stage or group of coils; which cylinders it serves is defined by the manufacturer, not by the code standard. It is a generic code, so it means the same on every make.
Is it safe to drive with P031D?
Drive gently and only to a workshop. With P031D the car can go into limp mode (reduced power) to protect itself.
Will P031D fail an emissions test?
Yes, it can. P031D is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P031D to fix?
Difficulty: medium. A typical repair takes 0.5 to 2.5 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P031D clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.