P03D5 code meaning
Cylinder 7 Pressure Sensor Circuit Intermittent/Erratic
Powertrain system Generic code P03xx codes Check engine light
What P03D5 means
Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 7. P03D5 means the sensor signal is erratic or drops out for moments – typically a loose contact at the glow plug connector, a chafed harness or sensor electronics unstable with temperature. The only manufacturer we found using this code family, GM's European 2.0 CDTI four-cylinder diesel (Saab 9-5, 2010), uses it for cylinders 1 to 4 as 'circuit erratic': signal outside its range for more than 0.2 s with the engine running. For cylinder 7, which only engines with at least 7 cylinders have, no manufacturer document available to us uses the code; the description follows that logic and CARB. The code often comes and goes.
P03D5 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyMedium
- Typical labor0.5 to 3 hours
- Clears after repairAfter a drive cycle
Symptoms of P03D5
- Check engine light on
- Occasionally rough running
- Often no symptoms, the code comes and goes
Common causes of P03D5
- Most likelyLoose contact at the glow plug connector
- PossibleChafing or broken wire in the engine harness
- PossibleSensor electronics of the glow plug unstable with temperature
- Less likelyInterference from ground problems
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Cylinder pressure sensor glow plugSensor wiringEngine control module
What each part of P03D5 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 3 | Area: ignition system or misfire. |
| D5 | The exact fault in that area. |
What to do next
- Note P03D5 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P03D5
What does P03D5 mean?
P03D5 means "Cylinder 7 Pressure Sensor Circuit Intermittent/Erratic". Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. It is a generic code, so it means the same on every make.
Is it safe to drive with P03D5?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P03D5 fail an emissions test?
Yes, it can. P03D5 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P03D5 to fix?
Difficulty: medium. A typical repair takes 0.5 to 3 hours of work. This is a job for a workshop.
Will P03D5 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.