P03F8 code meaning
B Camshaft Position Actuator Position Sensor C Circuit Low Bank 1
Powertrain system Generic code P03xx codes Check engine light
What P03F8 means
On some engines the exhaust cam phaser (camshaft position actuator B) has its own position sensors, which tell the engine module where the phaser actually is; sensor C is the third of them, bank 1 the side with cylinder 1. This is a different family from the sliding-cam position sensors (P2C05 ff). P03F8 means the signal stays below its lower limit – signal wire shorted to ground, 5 V supply open, or the sensor shorted internally. No manufacturer document available to us uses this code (GM, Ford and FCA tables checked); the intake counterpart P03E5 ff is equally unused. The phaser is then usually held in its base position.
P03F8 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium
- Typical labor0.5 to 3 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P03F8
- Check engine light on
- Exhaust cam phasing held in its base position, loss of power
- Possibly rough idle or poorer emissions
Common causes of P03F8
- Most likelySignal wire shorted to ground or 5 V supply open
- PossibleSensor faulty internally
- PossibleConnector corroded
- Less likelyEngine module
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Cam phaser position sensor cCam phaser exhaust bank1Sensor wiringEngine control module
What each part of P03F8 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 3 | Area: ignition system or misfire. |
| F8 | The exact fault in that area. |
What to do next
- Note P03F8 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P03F8
What does P03F8 mean?
P03F8 means "B Camshaft Position Actuator Position Sensor C Circuit Low Bank 1". On some engines the exhaust cam phaser (camshaft position actuator B) has its own position sensors, which tell the engine module where the phaser actually is; sensor C is the third of them, bank 1 the side with cylinder 1. It is a generic code, so it means the same on every make.
Is it safe to drive with P03F8?
Drive gently and only to a workshop. With P03F8 the car can go into limp mode (reduced power) to protect itself.
Will P03F8 fail an emissions test?
Yes, it can. P03F8 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P03F8 to fix?
Difficulty: medium. A typical repair takes 0.5 to 3 hours of work. This is a job for a workshop.
Will P03F8 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.