P040E code meaning
EGR Temperature Sensor A Circuit Intermittent/Erratic
Powertrain system Generic code P04xx codes Check engine light
What P040E means
EGR temperature sensor A measures the gas temperature in the EGR path – for cooler monitoring, component protection and the EGR model. Whether it sits before or after the cooler depends on the maker: GM diesels have sensor A after and B before the cooler, Ford diesels sensor B after it. Like a coolant sensor it is an NTC, so a low voltage means hot. P040E means the signal jumps. GM diesels of 2016–18 set it when the measured resistance changes by more than 25 Ω between two samples 100 ms apart – faster than any real temperature change, so a loose contact or a cracked sensor is the cause (40 of 50 samples, MIL after two trips). Ford and GM's earlier Duramax LML do not use the code.
P040E at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyEasy, DIY possible
- Typical labor0.5 to 1.5 hours
- Clears after repairAfter a drive cycle
Symptoms of P040E
- Check engine light on, may come and go
- No change in driving
Common causes of P040E
- Most likelyLoose contact in the connector or chafed wire
- PossibleSensor with an internal hairline crack
- PossibleCorroded pins
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
EGR temperature sensor aEGR coolerSensor wiringEngine control module
What each part of P040E means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 4 | Area: auxiliary emission controls (catalytic converter, EGR, EVAP). |
| 0E | The exact fault in that area. |
What to do next
- Note P040E and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P040E
What does P040E mean?
P040E means "EGR Temperature Sensor A Circuit Intermittent/Erratic". EGR temperature sensor A measures the gas temperature in the EGR path – for cooler monitoring, component protection and the EGR model. It is a generic code, so it means the same on every make.
Is it safe to drive with P040E?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P040E fail an emissions test?
Yes, it can. P040E is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P040E to fix?
Difficulty: easy. A typical repair takes 0.5 to 1.5 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P040E clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.