P0424 code meaning
Heated Catalyst Temperature Below Threshold Bank 1
Powertrain system Generic code P04xx codes Check engine light
What P0424 means
An electrically heated catalyst has a heating disc ahead of a support catalyst so that it works soon after a cold start (Emitec EMICAT, 12–48 V); it was tried on Californian gasoline cars in the 1990s and is used today mainly on diesels, for example Audi's 3.0 TDI from 2014 and 48-volt diesel vans. P0424 implements CARB's heated-catalyst rule for bank 1 (the side with cylinder 1): the catalyst must reach its intended temperature within a time set by the manufacturer after the start, measured by a temperature sensor or modelled from heating power. If it does not, the heater is too weak – supply voltage, contact resistance, an ageing element – or heat losses are too high. An open heater circuit is reported as P0429/P0439 instead. No manufacturer document available to us uses this code.
P0424 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyHard
- Typical labor0.5 to 4 hours
- Clears after repairAfter a drive cycle
Symptoms of P0424
- Check engine light on
- Higher emissions after a cold start
- Otherwise usually unremarkable
Common causes of P0424
- PossibleHeating element aged or partly faulty
- PossibleSupply too weak (battery, 48 V system, relay, contact resistance)
- PossibleCatalyst temperature sensor reads wrong
- Less likelyEngine module or calibration
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Electrically heated catalystCatalyst heaterCatalyst temperature sensorEngine control module
What each part of P0424 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 4 | Area: auxiliary emission controls (catalytic converter, EGR, EVAP). |
| 24 | The exact fault in that area. |
What to do next
- Note P0424 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0424
What does P0424 mean?
P0424 means "Heated Catalyst Temperature Below Threshold Bank 1". An electrically heated catalyst has a heating disc ahead of a support catalyst so that it works soon after a cold start (Emitec EMICAT, 12–48 V); it was tried on Californian gasoline cars in the 1990s and is used today mainly on diesels, for example Audi's 3.0 TDI from 2014 and 48-volt diesel vans. It is a generic code, so it means the same on every make.
Is it safe to drive with P0424?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P0424 fail an emissions test?
Yes, it can. P0424 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P0424 to fix?
Difficulty: hard. A typical repair takes 0.5 to 4 hours of work. This is a job for a workshop.
Will P0424 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.