P05D6 code meaning
Driver Mode Select Switch B Circuit High
Powertrain system Generic code P05xx codes Check engine light
What P05D6 means
The driver mode select switch (tour, sport, eco, snow, off-road, towing) changes engine and transmission maps such as shift points, pedal map and cylinder deactivation, so CARB requires it to be monitored as an input. GM reads switch A as an eight-position resistor ladder in the body module and sets P05D1–P05D3 in its 2025 tables when a condition is present for 4 s within 5 s, type B with warning lamp after two trips. A fault blocks mode selection; the vehicle stays in its basic mode. No manufacturer document available to us uses codes for switch B (a second mode switch or second signal line); its monitoring is assumed to match switch A. P05D6 means its signal is above the valid range – with a pull-up usually an open circuit, otherwise a short to positive, like P05D2 for switch A.
P05D6 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyMedium, DIY possible
- Typical labor0.5 to 1.5 hours
- Clears after repairAfter a drive cycle
Symptoms of P05D6
- Mode selection via switch B inoperative
- Check engine light possible
- Vehicle stays in its basic mode
Common causes of P05D6
- Most likelyConnector off or wire open
- PossibleSwitch B faulty
- Less likelyShort to positive
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Drive mode switchSwitch wiringBody control module
What each part of P05D6 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 5 | Area: vehicle speed, idle control and auxiliary inputs. |
| D6 | The exact fault in that area. |
What to do next
- Note P05D6 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P05D6
What does P05D6 mean?
P05D6 means "Driver Mode Select Switch B Circuit High". The driver mode select switch (tour, sport, eco, snow, off-road, towing) changes engine and transmission maps such as shift points, pedal map and cylinder deactivation, so CARB requires it to be monitored as an input. It is a generic code, so it means the same on every make.
Is it safe to drive with P05D6?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P05D6 fail an emissions test?
Yes, it can. P05D6 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P05D6 to fix?
Difficulty: medium. A typical repair takes 0.5 to 1.5 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P05D6 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.