P0760 code meaning
Shift Solenoid C
Powertrain system Generic code P07xx codes Check engine light
What P0760 means
A shift solenoid is an electrically switched valve in the valve body. Manufacturers use these codes differently: Ford reports an open circuit with the base code and shorts separately, and the letter is not tied to a valve number (Saab's Aisin 9-5: C = valve S4, D = valve S5). P0760 is the general code for solenoid C and, at Ford, means an open circuit: the smart driver feedback disagrees with the command for 0.5–5 s, continuously; shorts to ground and power are P0979/P0980. On Ford's 6R80, 6F35/6F55 and 6R140, solenoid C is the proportional valve of the CB26 brake for second and sixth gear. If the solenoid supply is switched off, Ford transmissions keep park, reverse, neutral and fifth gear with maximum pressure.
P0760 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium
- Typical labor0.5 to 4 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P0760
- Check engine or transmission warning lamp
- Limp mode in a fixed gear (Ford: fifth with maximum pressure)
- Second and sixth gear missing (Ford CB26)
Common causes of P0760
- Most likelyOpen or corroded wire, connector or internal harness
- PossibleSolenoid coil open or shorted
- Less likelySolenoid supply (high-side switch) missing
- Less likelyModule driver faulty
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Shift solenoidTransmission valve bodyTransmission wiringTransmission control module
What each part of P0760 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 7 | Area: transmission. |
| 60 | The exact fault in that area. |
What to do next
- Note P0760 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0760
What does P0760 mean?
P0760 means "Shift Solenoid C". A shift solenoid is an electrically switched valve in the valve body. It is a generic code, so it means the same on every make.
Is it safe to drive with P0760?
Drive gently and only to a workshop. With P0760 the car can go into limp mode (reduced power) to protect itself.
Will P0760 fail an emissions test?
Yes, it can. P0760 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P0760 to fix?
Difficulty: medium. A typical repair takes 0.5 to 4 hours of work. This is a job for a workshop.
Will P0760 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.