P07BF code meaning
Input/Turbine Shaft Speed Sensor A Circuit Low
Powertrain system Generic code P07xx codes Check engine light
What P07BF means
These low/high codes are a purely electrical check of the sensor's signal voltage at the module and run even with the vehicle at rest – unlike the circuit, range, no-signal and intermittent codes, which evaluate speed while driving. Low means a short to ground, high a short to supply or, depending on the circuit, an open. GM's transmission modules from 2019 (9-speed, 10-speed) flag below 0.25 V or above 4.75 V – a short of under 0.5 Ω – for more than 0.05 s with the system above 10 V for 5 s, after one trip. P07BF is the low side: a short to ground of the input sensor. A GM bulletin for 2019 nine-speed models (Enclave, Equinox, Malibu, XT4 and others) traces intermittent P07BF/P07C0 together with P0717 to an open inside the input speed sensor.
P07BF at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium
- Typical labor1 to 4 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P07BF
- Check engine light (GM after one trip)
- Limp mode, harsh shifts, no converter lock-up
- Adaption frozen
Common causes of P07BF
- Most likelySignal or supply wire shorted to ground (chafing at the case)
- PossibleSensor shorted internally
- PossibleOil or moisture in the connector
- Less likelyModule input faulty
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Input speed sensorSensor wiringTransmission control module
What each part of P07BF means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 7 | Area: transmission. |
| BF | The exact fault in that area. |
What to do next
- Note P07BF and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P07BF
What does P07BF mean?
P07BF means "Input/Turbine Shaft Speed Sensor A Circuit Low". These low/high codes are a purely electrical check of the sensor's signal voltage at the module and run even with the vehicle at rest – unlike the circuit, range, no-signal and intermittent codes, which evaluate speed while driving. It is a generic code, so it means the same on every make.
Is it safe to drive with P07BF?
Drive gently and only to a workshop. With P07BF the car can go into limp mode (reduced power) to protect itself.
Will P07BF fail an emissions test?
Yes, it can. P07BF is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P07BF to fix?
Difficulty: medium. A typical repair takes 1 to 4 hours of work. This is a job for a workshop.
Will P07BF clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.