P0830 code meaning
Clutch Pedal Switch A Circuit
What P0830 means
Clutch pedal switches A and B are digital inputs of manual gearboxes: they release the starter only with the pedal pressed, switch off cruise control and tell start-stop whether the clutch is open. Which switch is A or B is up to each manufacturer – FCA calls the pedal-up switch A. Ford's 2020–23 summary checks a dual switch over more than 40 pedal applications and reports a stuck switch without MIL (P0830 stuck high, P0833 stuck low, comparison P0704). P0830 is the general fault of switch A. On Ford it means the switch is stuck high. On a 2012–13 Jeep Wrangler with the six-speed manual, Chrysler reprogrammed the engine module for unwanted cruise control cut-outs with P0830; an FCA tip notes that a driver resting a foot on the pedal keeps the pedal-up switch on and sets the code. The MIL depends on the manufacturer.
P0830 at a glance
- Check engine lightUsually not
- Emissions testNot an emissions code
- Limp modeNot expected
- Repair difficultyEasy, DIY possible
- Typical labor0.3 to 1 hours
- Clears after repairAfter a drive cycle
Symptoms of P0830
- Cruise control switches off or cannot be activated
- Start-stop disabled
- Engine may not crank (starter interlock)
Common causes of P0830
- Most likelySwitch faulty or misadjusted
- PossibleFoot resting on the clutch pedal keeps the switch actuated
- PossibleSoftware misjudgment (reprogramming)
- Less likelyWiring, connector or remote-start bypass
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Clutch pedal switchSwitch wiringEngine control module
What each part of P0830 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 8 | Area: transmission. |
| 30 | The exact fault in that area. |
What to do next
- Note P0830 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0830
What does P0830 mean?
P0830 means "Clutch Pedal Switch A Circuit". Clutch pedal switches A and B are digital inputs of manual gearboxes: they release the starter only with the pedal pressed, switch off cruise control and tell start-stop whether the clutch is open. It is a generic code, so it means the same on every make.
Is it safe to drive with P0830?
P0830 does not normally turn on the check engine light by itself. Watch for the symptoms above and have it checked soon.
Will P0830 fail an emissions test?
P0830 is not an emissions code, so on its own it usually does not fail an emissions test. Other stored codes or a lit check engine light still can.
How hard is P0830 to fix?
Difficulty: easy. A typical repair takes 0.3 to 1 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P0830 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.