P0862 code meaning
Gear Shift Control Module A Communication Circuit High
Powertrain system Generic code P08xx codes Check engine light
What P0862 means
Gear shift control modules A and B are selector modules of shift-by-wire systems, such as Audi's selector lever J587 or Stellantis' rotary shift module. The codes cover a dedicated link to the gearbox module and the module's plausibility. If the selected range cannot be transferred reliably, the gearbox holds its range, goes to P at standstill or into limp mode. Modules on CAN report lost communication as U0103 or invalid data as U0404 instead; GM uses its own codes. P0862 means the link to module A stays at a high level: a short to voltage, or an open line held high by the receiver's pull-up. No maker documents it.
P0862 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium
- Typical labor0.5 to 3 hours
- Clears after repairAfter a drive cycle
Symptoms of P0862
- Selector or gearbox warning in the instrument cluster
- Range cannot be selected or only with delay, car stays in P/N
- Gearbox limp mode
Common causes of P0862
- Most likelyCommunication line shorted to voltage
- PossibleOpen line with pull-up in the receiver
- PossibleSoftware of selector or gearbox module
- PossibleSelector module faulty
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Electronic shift moduleTransmission control moduleSerial data lineModule wiring
What each part of P0862 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 8 | Area: transmission. |
| 62 | The exact fault in that area. |
What to do next
- Note P0862 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0862
What does P0862 mean?
P0862 means "Gear Shift Control Module A Communication Circuit High". Gear shift control modules A and B are selector modules of shift-by-wire systems, such as Audi's selector lever J587 or Stellantis' rotary shift module. It is a generic code, so it means the same on every make.
Is it safe to drive with P0862?
Drive gently and only to a workshop. With P0862 the car can go into limp mode (reduced power) to protect itself.
Will P0862 fail an emissions test?
Yes, it can. P0862 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P0862 to fix?
Difficulty: medium. A typical repair takes 0.5 to 3 hours of work. This is a job for a workshop.
Will P0862 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.