P0932 code meaning
Hydraulic Pressure Sensor Circuit
Powertrain system Generic code P09xx codes Check engine light
What P0932 means
General electrical fault in the circuit of the sensor that reports hydraulic pressure in the gearbox, usually line pressure in an automatic or system pressure in an automated manual or dual-clutch unit. The module sees a signal it cannot use at all, without a clear low or high pattern. Chrysler names it Line Pressure Sensor Circuit Fault; an ALLDATA case on a 2003 Grand Cherokee 4.7 automatic shows it together with P0935, caused by an open line pressure solenoid in the solenoid pack. CARB requires circuit checks on such transmission inputs. P0934 and P0935 are the low and high faults, P0933 the plausibility fault, P0936 the intermittent one. Expect harsh shifts, often with line pressure forced to maximum.
P0932 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium
- Typical labor0.5 to 3 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P0932
- Warning light or transmission warning on
- Harsh engagements and firm shifts from maximum line pressure
- Possible limp mode with limited gears
Common causes of P0932
- Most likelyFault in the solenoid pack or valve body module that carries the pressure sensor (open solenoid, internal lead frame)
- PossiblePoor crimp or solder joint at the sensor connector terminals
- Possible5 V reference or sensor ground interrupted
- Less likelyTransmission or powertrain control module fault
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Hydraulic pressure sensorWiring harnessTCM
What each part of P0932 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 9 | Area: transmission. |
| 32 | The exact fault in that area. |
What to do next
- Note P0932 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0932
What does P0932 mean?
P0932 means "Hydraulic Pressure Sensor Circuit". General electrical fault in the circuit of the sensor that reports hydraulic pressure in the gearbox, usually line pressure in an automatic or system pressure in an automated manual or dual-clutch unit. It is a generic code, so it means the same on every make.
Is it safe to drive with P0932?
Drive gently and only to a workshop. With P0932 the car can go into limp mode (reduced power) to protect itself.
Will P0932 fail an emissions test?
Yes, it can. P0932 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P0932 to fix?
Difficulty: medium. A typical repair takes 0.5 to 3 hours of work. This is a job for a workshop.
Will P0932 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.