P0967 code meaning
Pressure Control Solenoid B Control Circuit High
Powertrain system Generic code P09xx codes Check engine light
What P0967 means
Pressure control solenoid B circuit high: a short to voltage, and on GM six-speeds also an open, since they have no P0964. For the Saab 9-4X 6T70, where B is clutch pressure solenoid 2 for the 3-5-reverse clutch, the module needs 1 s, stores a Type A code and limits the transmission to reverse and 3rd gear at maximum line pressure; GM's 2018 six-speed table uses 0.3 s and one trip. GM's 8-speed (clutch 2), the 9- and 10-speeds, Allison 1000 (power short within 75 ms) and GM's dual-clutch gearbox (even-clutch valve) report the same fault on their solenoid B. Ford does not use it. Siblings: P0964 open, P0966 low, P0965 performance. Repairs usually involve the solenoid body or valve body module.
P0967 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyHard
- Typical labor1 to 5 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P0967
- MIL on, limp mode in a fixed gear
- Harsh engagements at maximum line pressure
- Dual-clutch gearbox loses the even gears
Common causes of P0967
- Most likelyOpen coil or poor connection (reported as high on GM six-speeds)
- PossibleControl wire shorted to a supply voltage
- PossibleDamaged or contaminated transmission connector
- Less likelyFaulty output stage in the control module
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Pressure control solenoid bWiring harnessTCM
What each part of P0967 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 9 | Area: transmission. |
| 67 | The exact fault in that area. |
What to do next
- Note P0967 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0967
What does P0967 mean?
P0967 means "Pressure Control Solenoid B Control Circuit High". Pressure control solenoid B circuit high: a short to voltage, and on GM six-speeds also an open, since they have no P0964. It is a generic code, so it means the same on every make.
Is it safe to drive with P0967?
Drive gently and only to a workshop. With P0967 the car can go into limp mode (reduced power) to protect itself.
Will P0967 fail an emissions test?
Yes, it can. P0967 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P0967 to fix?
Difficulty: hard. A typical repair takes 1 to 5 hours of work. This is a job for a workshop.
Will P0967 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.