P0DA0 code meaning
Battery Charger A Coupler Lock Position Sensor Circuit Low
What P0DA0 means
P0DA0 means the lock position feedback sits at the bottom of its range, typically from a signal wire shorted to ground. Mitsubishi documents it for the 2023 Outlander PHEV: with the IGCT supply on, the PHEV-ECU detects a low input from the lock position reading. The sensor sits in the charge connector lock actuator, part of the inlet harness; the signal line should carry battery voltage at the unplugged connector, and the sensor should measure 16.8 kΩ, give or take 0.84 kΩ. Depending on the result, technicians repair the line, replace the inlet harness or replace the PHEV-ECU. Ford names P0DA0:00 in TSBs 22-2355 and 23-2014 for its 2021 to 2023 electric models, alongside P0D9E, after a broken lock pin; there only the actuator is replaced. The opposite fault is P0DA1.
P0DA0 at a glance
- Check engine lightUsually not
- Emissions testNot an emissions code
- Limp modeNot expected
- Repair difficultyMedium
- Typical labor0.5 to 2 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P0DA0
- DC fast charging not possible
- Charger Service Required message (Ford)
- Plug is not latched or charging ends right after start
Common causes of P0DA0
- Most likelyLock position signal line shorted to ground (Mitsubishi)
- PossibleActuator pin broken after the plug was pulled while latched (Ford)
- PossiblePosition sensor in the inlet harness outside its resistance specification
- Less likelyPHEV-ECU input defective
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Charge port lock actuatorWiring harnessOn board charger
What each part of P0DA0 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| A0 | The exact fault in that area. |
What to do next
- Note P0DA0 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0DA0
What does P0DA0 mean?
P0DA0 means "Battery Charger A Coupler Lock Position Sensor Circuit Low". P0DA0 means the lock position feedback sits at the bottom of its range, typically from a signal wire shorted to ground. It is a generic code, so it means the same on every make.
Is it safe to drive with P0DA0?
P0DA0 does not normally turn on the check engine light by itself. Watch for the symptoms above and have it checked soon.
Will P0DA0 fail an emissions test?
P0DA0 is not an emissions code, so on its own it usually does not fail an emissions test. Other stored codes or a lit check engine light still can.
How hard is P0DA0 to fix?
Difficulty: medium. A typical repair takes 0.5 to 2 hours of work. This is a job for a workshop.
Will P0DA0 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.