P0ED5 code meaning
Generator Phase X Current Low
Powertrain system Generic code P0Exx codes Check engine light
What P0ED5 means
P0ED5 means that phase X of the hybrid generator carries, or appears to carry, too little current while the generator is supposed to deliver torque. No manufacturer documents P0ED5 publicly. Mitsubishi publishes a comparable check for the U, V and W phases of the 2023 Outlander PHEV: with at least 50 A requested and the generator between 500 and 4,500 rpm, a phase current that stays within roughly 17 A of zero for 0.4 s sets P0E0C, as does a failed comparison with the target current. In phase X the same result comes from a broken phase cable, a burnt winding joint, an inverter switch that never conducts, or a current sensor stuck at its zero point. P0ED6 is the high case; the low codes of phases Y and Z are P0ED8 and P0EDB. Generator torque and charging suffer.
P0ED5 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyWorkshop only
- Typical labor1 to 8 hours
- Clears after repairAfter a drive cycle
Symptoms of P0ED5
- Weak or no battery charging by the generator
- Rough engine start or vibration from the generator
- MIL and hybrid warning
Common causes of P0ED5
- Most likelyOpen or loose phase X cable or terminal
- PossibleInverter power switch for phase X not conducting
- Less likelyBurnt or broken winding connection in the generator
- Less likelyCurrent sensor stuck near zero
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Generator phase xInverter
What each part of P0ED5 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| D5 | The exact fault in that area. |
What to do next
- Note P0ED5 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0ED5
What does P0ED5 mean?
P0ED5 means "Generator Phase X Current Low". P0ED5 means that phase X of the hybrid generator carries, or appears to carry, too little current while the generator is supposed to deliver torque. It is a generic code, so it means the same on every make.
Is it safe to drive with P0ED5?
Drive gently and only to a workshop. With P0ED5 the car can go into limp mode (reduced power) to protect itself.
Will P0ED5 fail an emissions test?
Yes, it can. P0ED5 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P0ED5 to fix?
Difficulty: workshop only. A typical repair takes 1 to 8 hours of work. This is a job for a workshop.
Will P0ED5 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.