P207E code meaning
Intake Manifold Tuning (IMT) Valve Position Sensor/Switch Circuit Intermittent (Bank 2)
Powertrain system Generic code P20xx codes Check engine light
What P207E means
Bank 2 version of the intermittent feedback fault: the valve position signal drops out or jumps for short moments, but returns to normal between events. No manufacturer documents P207E, and even its bank 1 twin P2079 has no published OEM use with this meaning. The diagnosis is therefore generic: since the fault may vanish before a scan tool is connected, freeze-frame data and the failure counter help to judge how often it happens. Heat cycling on the rear bank, vibration and water in the connector are the usual triggers. If the signal fails permanently, the code typically turns into the circuit or low/high variants P207A, P207C or P207D, which are easier to pinpoint.
P207E at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyMedium, DIY possible
- Typical labor0.5 to 3 hours
- Clears after repairAfter a drive cycle
Symptoms of P207E
- Intermittent warning light (manufacturer-dependent)
- Fault not reproducible in the workshop
Common causes of P207E
- Most likelyMoisture or corrosion in the bank 2 sensor connector
- PossibleSolder joint or wire breaking open intermittently under heat
- Less likelyHarness not clipped, contact lost under vibration
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Imt position sensor
What each part of P207E means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 0 | Area: fuel and air metering and auxiliary emission controls. |
| 7E | The exact fault in that area. |
What to do next
- Note P207E and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P207E
What does P207E mean?
P207E means "Intake Manifold Tuning (IMT) Valve Position Sensor/Switch Circuit Intermittent (Bank 2)". Bank 2 version of the intermittent feedback fault: the valve position signal drops out or jumps for short moments, but returns to normal between events. It is a generic code, so it means the same on every make.
Is it safe to drive with P207E?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P207E fail an emissions test?
Yes, it can. P207E is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P207E to fix?
Difficulty: medium. A typical repair takes 0.5 to 3 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P207E clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.