P2092 code meaning
"A" Camshaft Position Actuator Control Circuit Low (Bank 2)
Powertrain system Generic code P20xx codes Check engine light
What P2092 means
P2092 is the Low fault of the intake phaser valve (actuator A) on bank 2, which exists only on V and boxer engines with a separate valve per bank. Bank 2 is the side without cylinder 1. GM's 3.6 L LFX V6 in table 19OBDG03B checks this output with the high-side logic known from bank 1: a short to ground while energised, below 0.5 ohms, 20 bad samples out of 25, Type A, lamp in the first trip. The low-side controller in GM table 23OBDG07 tests the line while switched off and confirms after 0.2 s. Ford's 2014 gasoline list includes P2092 but marks it only for the continuous monitor, not for the key-on or running self-test. If only bank 2 reports a fault, compare the valve resistance with the bank 1 valve and look for chafing where the harness crosses the cylinder head.
P2092 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium, DIY possible
- Typical labor0.4 to 2.5 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P2092
- Engine warning lamp on, immediately on GM LFX
- Uneven running between banks, weaker torque
Common causes of P2092
- Most likelyBank 2 intake valve wire shorted to ground on the cylinder head
- PossibleShorted coil in the bank 2 intake oil control valve
- Less likelyOil inside the valve connector
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Oil control valve intake bank2Oil control valve wiringEngine control module
What each part of P2092 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 0 | Area: fuel and air metering and auxiliary emission controls. |
| 92 | The exact fault in that area. |
What to do next
- Note P2092 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2092
What does P2092 mean?
P2092 means ""A" Camshaft Position Actuator Control Circuit Low (Bank 2)". P2092 is the Low fault of the intake phaser valve (actuator A) on bank 2, which exists only on V and boxer engines with a separate valve per bank. It is a generic code, so it means the same on every make.
Is it safe to drive with P2092?
Drive gently and only to a workshop. With P2092 the car can go into limp mode (reduced power) to protect itself.
Will P2092 fail an emissions test?
Yes, it can. P2092 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P2092 to fix?
Difficulty: medium. A typical repair takes 0.4 to 2.5 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P2092 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.