P2706 code meaning
Shift Solenoid F
Powertrain system Generic code P27xx codes Check engine light
What P2706 means
P2706 is the general code for the sixth shift solenoid, F. Ford's 2024 OBD summary uses it as the base for all shift solenoid F faults in its 10R60/10R80, 8F35/8F40, 8F57 and 8F24 transmissions: with a fault-type byte added, P2706 marks an open, a short to ground, a short to supply, an intermittent connection, stuck off and stuck on, each also carrying its own two-byte code such as P097F, P2707 or P2708. Ford's electrical check flags a fault once the smart driver has reported a wiring problem for 1.5 s. Stellantis calls the same position the MS solenoid on the Ram 68RFE, where bulletin 18-061-20 lists P2706 among codes cleared by new engine controller software. Ford's SSM 54595 names it with P2707 on 8F35 units that will not leave Park. Shifts involving the related clutch become harsh or are blocked.
P2706 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyHard
- Typical labor0.5 to 8 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P2706
- Harsh shifts, missing gears or limp mode
- Vehicle may not shift out of Park on some Ford 8F35 units
- Warning light on
Common causes of P2706
- Most likelyOpen or shorted wiring or connector to shift solenoid F, often inside the transmission
- PossibleFailed shift solenoid F or main control valve body
- PossibleControl module software that needs reprogramming (Ram 68RFE)
- Less likelyFaulty solenoid driver in the PCM or TCM
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Shift solenoid fValve body
What each part of P2706 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 7 | Area: transmission. |
| 06 | The exact fault in that area. |
What to do next
- Note P2706 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2706
What does P2706 mean?
P2706 means "Shift Solenoid F". P2706 is the general code for the sixth shift solenoid, F. It is a generic code, so it means the same on every make.
Is it safe to drive with P2706?
Drive gently and only to a workshop. With P2706 the car can go into limp mode (reduced power) to protect itself.
Will P2706 fail an emissions test?
Yes, it can. P2706 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P2706 to fix?
Difficulty: hard. A typical repair takes 0.5 to 8 hours of work. This is a job for a workshop.
Will P2706 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.