P2806 code meaning
Transmission Range Sensor Alignment
What P2806 means
P2806 says that the selector position reported by the range sensor and the actual mechanical position of the gearbox do not line up. Ford is the only public user found. Its 2019 hybrid OBD summary lists the code for the eCVT with the wrench lamp and without the MIL; one section defines a park pawl check behind it: if the park motor turns more than 9 radians while the pawl should already be engaged, the code is set. Another section for the same family checks sensor voltages against fixed windows for each position. Common causes are a sensor moved on its shaft after service, a worn selector cable or linkage, or a damaged park mechanism. Re-adjust or replace the sensor and confirm Park holds before driving.
P2806 at a glance
- Check engine lightUsually not
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium
- Typical labor0.5 to 4 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P2806
- Wrench lamp, gear display differs from lever position
- Vehicle may roll in Park
- Start refused in Park or Neutral
Common causes of P2806
- Most likelyRange sensor not aligned correctly after transmission work
- PossibleStretched selector cable or worn linkage
- PossiblePark pawl or park motor mechanism damaged
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Transmission range sensorSelector linkage
What each part of P2806 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 8 | Area: transmission. |
| 06 | The exact fault in that area. |
What to do next
- Note P2806 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2806
What does P2806 mean?
P2806 means "Transmission Range Sensor Alignment". P2806 says that the selector position reported by the range sensor and the actual mechanical position of the gearbox do not line up. It is a generic code, so it means the same on every make.
Is it safe to drive with P2806?
Drive gently and only to a workshop. With P2806 the car can go into limp mode (reduced power) to protect itself.
Will P2806 fail an emissions test?
Yes, it can. P2806 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P2806 to fix?
Difficulty: medium. A typical repair takes 0.5 to 4 hours of work. This is a job for a workshop.
Will P2806 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.