P282D code meaning
Pressure Control Solenoid K Control Circuit/Open
Powertrain system Generic code P28xx codes Check engine light
What P282D means
P282D marks an open control circuit of solenoid K. GM's 2023 Corvette dual-clutch software applies it to the selector pilot valve. With the low-side output off, a connected coil would pull the sense pin up to battery voltage; the driver instead attempts to keep the pin near ground using a very small current, and if the voltage settles between roughly 1.7 and 3 V the load is considered missing. Once 100 ms of confirmation have passed, the TCM logs a Type A fault and lights the MIL in the same drive. The test only runs between about 8.75 and 18 V and not during cranking. Ford's TR9070 reports an open selector pilot valve as P27DD rather than under K. Broken wires, a pushed-back terminal or an open coil leave the selector unable to switch between shift rods.
P282D at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyHard
- Typical labor1 to 6 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P282D
- Gears on one shaft unavailable
- MIL on immediately
- Limp mode
Common causes of P282D
- Most likelyBroken wire to the selector pilot valve
- PossibleTerminal pushed back in the connector
- PossibleOpen coil in solenoid K
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Pressure control solenoid kWiring harness
What each part of P282D means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 8 | Area: transmission. |
| 2D | The exact fault in that area. |
What to do next
- Note P282D and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P282D
What does P282D mean?
P282D means "Pressure Control Solenoid K Control Circuit/Open". P282D marks an open control circuit of solenoid K. It is a generic code, so it means the same on every make.
Is it safe to drive with P282D?
Drive gently and only to a workshop. With P282D the car can go into limp mode (reduced power) to protect itself.
Will P282D fail an emissions test?
Yes, it can. P282D is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P282D to fix?
Difficulty: hard. A typical repair takes 1 to 6 hours of work. This is a job for a workshop.
Will P282D clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.