P2C60 code meaning
Cylinder 8 Fuel Injector B Offset Learning At Min Limit
Powertrain system Generic code P2Cxx codes Check engine light
What P2C60 means
P2C60 is the minimum-limit code for injector B on cylinder 8, the last cylinder of a V8 and the end of this code series. Its A-side twin P02DA is documented by GM for the L5P diesel and by Land Rover for a 5.0 V8, but the B version has no public manufacturer source at all. The physics are the same as on the other cylinders: the learned correction has shortened the pulse to the floor because this valve keeps overdelivering. On a V8 a dripping injector on cylinder 8 often shows up as a rough first few seconds after a hot start, sometimes with a misfire record for cylinder 8 (P0308). Under both Ford and GM numbering it sits on bank 2. CARB 1968.2 (e)(6.2.2) requires the check.
P2C60 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyMedium
- Typical labor0.5 to 5 hours
- Clears after repairAfter a drive cycle
Symptoms of P2C60
- Check engine light
- Often nothing else noticeable
- Long hot start or rough first seconds, possibly misfire on cylinder 8
- Possibly fuel smell or higher consumption
Common causes of P2C60
- Most likelyInjector B of cylinder 8 leaking at the seat and adding fuel after closing
- PossibleReplacement injector of a different flow rating or not matched to the engine software
- PossibleOld learned values not reset after injector or software work
- Less likelySupply pressure on this injector set higher than the model assumes (regulator)
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Fuel injector b cyl 8ECM
What each part of P2C60 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| C | Area: hybrid propulsion. |
| 60 | The exact fault in that area. |
What to do next
- Note P2C60 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2C60
What does P2C60 mean?
P2C60 means "Cylinder 8 Fuel Injector B Offset Learning At Min Limit". P2C60 is the minimum-limit code for injector B on cylinder 8, the last cylinder of a V8 and the end of this code series. It is a generic code, so it means the same on every make.
Is it safe to drive with P2C60?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P2C60 fail an emissions test?
Yes, it can. P2C60 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P2C60 to fix?
Difficulty: medium. A typical repair takes 0.5 to 5 hours of work. This is a job for a workshop.
Will P2C60 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.