P2E0E code meaning
Gear Lever Position Sensor D Circuit Low
Powertrain system Generic code P2Exx codes Check engine light
What P2E0E means
P2E0E is set when the output of gear lever position sensor D drops beneath its lowest plausible level, usually near 0 V or 0 % duty cycle. Likely reasons are a ground short in the D signal path, a sensor without feed or a Hall element whose output died. No maker publishes P2E0E or a meaning for sensor D. Toyota's patent US10180184 treats such hard electrical faults as continuously detectable and keeps the shift position available from the three other sensors; a second abnormality then calls for a fail-safe such as neutral. For comparison, GM flags low per axis on its two-sensor XT4 lever below 5 % duty cycle (P082E, P08A1). Out-of-range detection is a CARB 1968.2 (e)(15) duty. Sensor D high is P2E0F, sensor C low P2E0A.
P2E0E at a glance
- Check engine lightYes, usually on
- Emissions testNot an emissions code
- Limp modePossible
- Repair difficultyMedium
- Typical labor0.5 to 3 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P2E0E
- Shift-system warning
- Selector still usable on the other sensors
- Shift to neutral if another sensor fails
Common causes of P2E0E
- Most likelySignal path of sensor D shorted to ground
- PossibleSensor D without supply
- PossibleHall element of sensor D failed low
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Gear lever position sensor dWiring harnessTCM
What each part of P2E0E means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 0E | The exact fault in that area. |
What to do next
- Note P2E0E and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2E0E
What does P2E0E mean?
P2E0E means "Gear Lever Position Sensor D Circuit Low". P2E0E is set when the output of gear lever position sensor D drops beneath its lowest plausible level, usually near 0 V or 0 % duty cycle. It is a generic code, so it means the same on every make.
Is it safe to drive with P2E0E?
Drive gently and only to a workshop. With P2E0E the car can go into limp mode (reduced power) to protect itself.
Will P2E0E fail an emissions test?
P2E0E is not an emissions code, so on its own it usually does not fail an emissions test. Other stored codes or a lit check engine light still can.
How hard is P2E0E to fix?
Difficulty: medium. A typical repair takes 0.5 to 3 hours of work. This is a job for a workshop.
Will P2E0E clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.