U0572 code meaning
Invalid Data Received From Vehicle Motion Control Module A
What U0572 means
A vehicle motion control module sits above the individual chassis controllers and coordinates steering, brakes, damping and drive torque. ZF's cubiX software works this way and went into production in the Lotus Eletre; Hitachi Astemo describes a central controller that sends time-referenced instructions to several actuator modules. U0572 means that one of these actuator controllers or the gateway receives such instructions or status data from module A but finds them invalid, for example out of range or with a broken counter or checksum. No manufacturer documents U0572 publicly, and there is no generic lost-communication code for this module. The receiving controllers then ignore the commands and fall back to their own functions.
U0572 at a glance
- Check engine lightUsually not
- Emissions testNot an emissions code
- Limp modePossible
- Repair difficultyWorkshop only
- Typical labor0.5 to 3 hours
- Clears after repairWhen cleared with a scanner
Symptoms of U0572
- Chassis or stability warning message
- Rear-axle steering, active roll control or drive modes switched off
- Car drives with basic stability control only
Common causes of U0572
- Most likelySoftware of motion control module and chassis controllers not matched
- PossibleMotion control module A internally faulty
- PossibleImplausible sensor input to the module (yaw, steering angle) leading to invalid outputs
- Less likelyDisturbed chassis network or gateway
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Vehicle motion control module a
What each part of U0572 means
| U | Network system: communication between the control modules (CAN bus). |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 72 | The exact fault in that area. |
What to do next
- Note U0572 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about U0572
What does U0572 mean?
U0572 means "Invalid Data Received From Vehicle Motion Control Module A". A vehicle motion control module sits above the individual chassis controllers and coordinates steering, brakes, damping and drive torque. It is a generic code, so it means the same on every make.
Is it safe to drive with U0572?
Drive gently and only to a workshop. With U0572 the car can go into limp mode (reduced power) to protect itself.
Will U0572 fail an emissions test?
U0572 is not an emissions code, so on its own it usually does not fail an emissions test. Other stored codes or a lit check engine light still can.
How hard is U0572 to fix?
Difficulty: workshop only. A typical repair takes 0.5 to 3 hours of work. This is a job for a workshop.
Will U0572 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.