B010E code meaning
Camera Washer Actuator E
What B010E means
B010E names actuator E, which may be a dedicated pump rather than a valve. Audi's TSB 2073568/1 (2024) for e-tron, e-tron S and Q8/SQ8 e-tron models reports rear camera washer pressure too low to clean the lens: the mono pump could not build enough pressure, and production moved to a dual pump (1K6 955 651) whose spare outlet is plugged. Before swapping it, technicians rule out low fluid, a clogged pump filter, low supply voltage and kinked lines. AUMOVIO lists its washer pumps with one or two outlets for 2.0 to 4.0 bar. A pump drawing no current or too much is the kind of fault a module can flag; whether any maker calls that pump E is not published, and no manufacturer documents B010E.
B010E at a glance
- Check engine lightUsually not
- Emissions testNot an emissions code
- Limp modeNot expected
- Repair difficultyMedium, DIY possible
- Typical labor0.5 to 1.5 hours
- Clears after repairWhen cleared with a scanner
Symptoms of B010E
- Camera nozzle only dribbles; the spray does not reach across the lens
- Pump hum without spray, or no pump sound at all when the wash is requested
Common causes of B010E
- Most likelyCamera washer pump motor E worn, seized or open
- PossibleLow supply voltage or poor ground at the pump
- Less likelyClogged inlet filter making the pump labour and draw high current
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Camera washer actuator eWasher pumpActuator wiring
What each part of B010E means
| B | Body system: airbags, seat belts, power seats, lights and climate control. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 0E | The exact fault in that area. |
What to do next
- Note B010E and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about B010E
What does B010E mean?
B010E means "Camera Washer Actuator E". B010E names actuator E, which may be a dedicated pump rather than a valve. It is a generic code, so it means the same on every make.
Is it safe to drive with B010E?
B010E does not normally turn on the check engine light by itself. Watch for the symptoms above and have it checked soon.
Will B010E fail an emissions test?
B010E is not an emissions code, so on its own it usually does not fail an emissions test. Other stored codes or a lit check engine light still can.
How hard is B010E to fix?
Difficulty: medium. A typical repair takes 0.5 to 1.5 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will B010E clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.