P075C code meaning
Shift Solenoid G Stuck On
Powertrain system Generic code P07xx codes Check engine light
What P075C means
Shift solenoid G only exists on transmissions with seven or more solenoids. Ford's 10R80 and 8F35 use solenoids A–F, GM's 9- and 10-speeds report clutch pressure valve codes, the Allison 1000 uses three; the only documented user of the G block is Hyundai/Genesis' 8-speed, which assigns P075A and P075D to its on/off solenoids. P075C means solenoid G is commanded off but its clutch stays applied, like P0752 for solenoid A. No manufacturer document available to us uses this code; Ford's 10-speed bulletins end at solenoid F. The description follows the scheme for solenoids A and B.
P075C at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyHard
- Typical labor1.5 to 12 hours
- Clears after repairAfter a drive cycle
Symptoms of P075C
- Wrong gear, tie-up
- Limp mode
- Check engine light
Common causes of P075C
- Most likelyShift spool sticking in the applied position
- PossibleSolenoid stuck open or leaking
- PossibleClutch not releasing (burnt or stuck)
- PossibleContaminated or wrong fluid
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Shift solenoidTransmission valve bodyTransmission wiringTransmission control module
What each part of P075C means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 7 | Area: transmission. |
| 5C | The exact fault in that area. |
What to do next
- Note P075C and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P075C
What does P075C mean?
P075C means "Shift Solenoid G Stuck On". Shift solenoid G only exists on transmissions with seven or more solenoids. It is a generic code, so it means the same on every make.
Is it safe to drive with P075C?
Drive gently and only to a workshop. With P075C the car can go into limp mode (reduced power) to protect itself.
Will P075C fail an emissions test?
Yes, it can. P075C is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P075C to fix?
Difficulty: hard. A typical repair takes 1.5 to 12 hours of work. This is a job for a workshop.
Will P075C clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.