P0762 code meaning
Shift Solenoid C Stuck On
Powertrain system Generic code P07xx codes Check engine light
What P0762 means
A shift solenoid is an electrically switched valve in the valve body; the module checks whether its clutch follows the command by gear ratio, shift time or a pressure switch. P0762 means solenoid C is commanded off but its clutch stays applied. GM's Honda-built five-speed flags a 2–3 shift slower than 0.8 s together with a 4–5 shift faster than 0.8 s, after two trips; the Allison 1000 a pressure switch 3 still applied after 2 s (up to 4 s when cold), after one trip. Ford calls it 'functionally failed on' – the CB26 brake does not release, which ties up the transmission when leaving second or sixth gear. Ford's 10R80 bulletins list it with a leaking clutch cylinder.
P0762 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyHard
- Typical labor1.5 to 12 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P0762
- Tie-up or jolt on shifts
- Delayed shifts, engine revs high
- Limp mode
- Check engine light
Common causes of P0762
- Most likelyShift spool or proportional valve sticking in the applied position
- PossibleClutch not releasing (stuck or burnt)
- PossibleSolenoid stuck open or leaking
- Less likelyControl wire shorted to ground (permanently powered)
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Shift solenoidTransmission valve bodyTransmission wiringTransmission control module
What each part of P0762 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 7 | Area: transmission. |
| 62 | The exact fault in that area. |
What to do next
- Note P0762 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0762
What does P0762 mean?
P0762 means "Shift Solenoid C Stuck On". A shift solenoid is an electrically switched valve in the valve body; the module checks whether its clutch follows the command by gear ratio, shift time or a pressure switch. It is a generic code, so it means the same on every make.
Is it safe to drive with P0762?
Drive gently and only to a workshop. With P0762 the car can go into limp mode (reduced power) to protect itself.
Will P0762 fail an emissions test?
Yes, it can. P0762 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P0762 to fix?
Difficulty: hard. A typical repair takes 1.5 to 12 hours of work. This is a job for a workshop.
Will P0762 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.