P07FE code meaning
Stuck in Gear Not Specified
Powertrain system Generic code P07xx codes Check engine light
What P07FE means
P07FE is the catch-all of the 'Stuck in Gear' family: the transmission stays in a gear it was commanded to leave, but the module cannot or does not name the gear. The gear-specific codes are P072B–P073C for reverse and gears 1–7, P07D7 for 8th, P07F8 for 9th and P07FB for 10th. No manufacturer document available to us uses P07FE; the gear-specific codes are documented on dual-clutch gearboxes such as Ford's DPS6 and Maserati's MC20, whose actuators move shift drums or forks. Typical causes are a sticking shift actuator or valve, low or unstable system pressure, mechanical damage, or a faulty position or speed signal.
P07FE at a glance
- Check engine lightYes, usually on
- Emissions testNot an emissions code
- Limp modePossible
- Repair difficultyHard
- Typical labor0.5 to 12 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P07FE
- Transmission no longer shifts and stays in one gear
- Limp mode, transmission warning
Common causes of P07FE
- PossibleShift actuator or shift valve sticking
- PossibleSystem pressure low or unstable
- PossibleMechanical damage in the gear train
- Less likelyPosition or speed sensor signal wrong
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Shift fork actuatorTransmission mechatronicsShift forkTransmission control module
What each part of P07FE means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 7 | Area: transmission. |
| FE | The exact fault in that area. |
What to do next
- Note P07FE and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P07FE
What does P07FE mean?
P07FE means "Stuck in Gear Not Specified". P07FE is the catch-all of the 'Stuck in Gear' family: the transmission stays in a gear it was commanded to leave, but the module cannot or does not name the gear. It is a generic code, so it means the same on every make.
Is it safe to drive with P07FE?
Drive gently and only to a workshop. With P07FE the car can go into limp mode (reduced power) to protect itself.
Will P07FE fail an emissions test?
P07FE is not an emissions code, so on its own it usually does not fail an emissions test. Other stored codes or a lit check engine light still can.
How hard is P07FE to fix?
Difficulty: hard. A typical repair takes 0.5 to 12 hours of work. This is a job for a workshop.
Will P07FE clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.