P092A code meaning
Gear Shift Lock Solenoid/Actuator Control Circuit B/Open
What P092A means
Reports an open on control circuit B of the shift lock. No manufacturer documents this code publicly, and none says which lock is B. One possible use is a second lock actuator: GHSP patents describe shifters where a further solenoid holds the lever in Neutral below a set speed unless the brake is pressed, beside the usual Park lock. CARB requires output circuits to be checked for continuity but may exempt safety-only systems. The FCA recall on the BTSI solenoid shows how such a lock fails in practice. P0928 is the same open fault on circuit A, P092B the plausibility fault, P092C and P092D the low and high faults of circuit B. Expect a lever that is locked in a position or no longer locked.
P092A at a glance
- Check engine lightUsually not
- Emissions testNot an emissions code
- Limp modeNot expected
- Repair difficultyMedium, DIY possible
- Typical labor0.5 to 2.5 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P092A
- Selector lever locked in one position although the brake is pressed
- Lock no longer engages, lever moves freely without brake
- Warning message about the shifter or transmission
Common causes of P092A
- Most likelyBroken wire or loose terminal on circuit B at the shifter
- PossibleOpen coil in the second lock solenoid
- Less likelyShifter connector not fully seated after console work
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Gear shift lock solenoid bWiring harnessTCM
What each part of P092A means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 9 | Area: transmission. |
| 2A | The exact fault in that area. |
What to do next
- Note P092A and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P092A
What does P092A mean?
P092A means "Gear Shift Lock Solenoid/Actuator Control Circuit B/Open". Reports an open on control circuit B of the shift lock. It is a generic code, so it means the same on every make.
Is it safe to drive with P092A?
P092A does not normally turn on the check engine light by itself. Watch for the symptoms above and have it checked soon.
Will P092A fail an emissions test?
P092A is not an emissions code, so on its own it usually does not fail an emissions test. Other stored codes or a lit check engine light still can.
How hard is P092A to fix?
Difficulty: medium. A typical repair takes 0.5 to 2.5 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P092A clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.