P0E05 code meaning
Generator Phase V Current Sensor Circuit Range/Performance
Powertrain system Generic code P0Exx codes Check engine light
What P0E05 means
P0E05 reports an implausible zero point of the current sensor in phase V of the generator inverter. Mitsubishi describes it only for the 2023 Outlander PHEV, the first of its generator units with a sensor in phase V; the earlier model measured just U and W. The test mirrors that of the other phases and runs at rest: IGBTs off, generator below 20 rpm, control unit fed with at least 8 V. If the V-phase signal then sits outside 2.3 to 2.7 V for 0.32 s, P0E05-00 is logged and the MIL turns on. As no current can flow in this state, any deviation points to the sensor itself. A zero error left in place would also disturb the three-phase sum check P0DFA, so both codes may appear together. Open or shorted signals of this sensor are P0E06 and P0E07.
P0E05 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyWorkshop only
- Typical labor1 to 5 hours
- Clears after repairAfter a drive cycle
Symptoms of P0E05
- MIL and hybrid system warning light on
- Possibly also the phase sum code P0DFA stored
- Less generator support during hybrid driving
Common causes of P0E05
- Most likelyZero point of the phase V current sensor drifted
- PossibleDisturbed sensor supply or reference in the power drive unit
- Less likelyGenerator control unit evaluation faulty
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Generator phase v current sensorWiring harnessHybrid control module
What each part of P0E05 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 05 | The exact fault in that area. |
What to do next
- Note P0E05 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P0E05
What does P0E05 mean?
P0E05 means "Generator Phase V Current Sensor Circuit Range/Performance". P0E05 reports an implausible zero point of the current sensor in phase V of the generator inverter. It is a generic code, so it means the same on every make.
Is it safe to drive with P0E05?
Drive gently and only to a workshop. With P0E05 the car can go into limp mode (reduced power) to protect itself.
Will P0E05 fail an emissions test?
Yes, it can. P0E05 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P0E05 to fix?
Difficulty: workshop only. A typical repair takes 1 to 5 hours of work. This is a job for a workshop.
Will P0E05 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.