P2019 code meaning
Intake Manifold Runner Position Sensor/Switch Circuit (Bank 2)
Powertrain system Generic code P20xx codes Check engine light
What P2019 means
P2019 is the bank 2 counterpart of P2014 and only appears on V or boxer engines with separate flap feedback per cylinder row. It reports an electrical fault in the position circuit without stating its direction. Volkswagen's Touareg hybrid of 2014 (CGFA) stores it once the bank 2 signal drops under 0.2 V. Ford's 2024 summary uses P2019 as the parent code for bank 2: failure byte 11 corresponds to the low code P2021, 15 to the high code P2022 and 92 to over-travel (P2020), all checked once coolant is above 40 °F. Ford's 2014 code list marks P2019 as lighting the MIL. If P2014 is stored as well, look for a shared reference or ground before replacing both sensors.
P2019 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyMedium, DIY possible
- Typical labor0.5 to 3 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P2019
- Check engine lamp on
- Mild loss of low-speed torque if the control unit parks the flaps
Common causes of P2019
- Most likelyBank 2 sensor wiring open or shorted
- PossibleBank 2 position sensor failed
- Less likelyShared 5 V reference or ground faulty (both banks affected)
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Imrc position sensor b2Imrc wiring
What each part of P2019 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 0 | Area: fuel and air metering and auxiliary emission controls. |
| 19 | The exact fault in that area. |
What to do next
- Note P2019 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2019
What does P2019 mean?
P2019 means "Intake Manifold Runner Position Sensor/Switch Circuit (Bank 2)". P2019 is the bank 2 counterpart of P2014 and only appears on V or boxer engines with separate flap feedback per cylinder row. It is a generic code, so it means the same on every make.
Is it safe to drive with P2019?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P2019 fail an emissions test?
Yes, it can. P2019 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P2019 to fix?
Difficulty: medium. A typical repair takes 0.5 to 3 hours of work. A careful DIY repair is possible with basic tools and a scanner.
Will P2019 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.