P2702 code meaning
Transmission Friction Element C Apply Time Range/Performance
Powertrain system Generic code P27xx codes Check engine light
What P2702 means
With P2702 the transmission controller reports that friction element C does not engage within the time it expects, measured from the shift command to the moment the speed ratio changes. Which clutch C stands for differs between gearbox designs. Ford names the code in several valve body bulletins. For 10R140 units in 2020 F-Super Duty trucks, TSB 20-2375 lists P2700 to P2705 among codes caused by sticking main control valves; below 8,000 km the dealer runs a break-in routine three times on the affected clutches, beyond that the valve body is replaced. SSM 54595 for 8F35 units in 2025 Maverick, Corsair, Escape and Bronco Sport built from September 2024 to September 2025 reports P2702 with P2706 and P2707 when the vehicle will not leave Park. Roush propane chassis store it without MIL.
P2702 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyWorkshop only
- Typical labor1 to 12 hours
- Clears after repairAfter a drive cycle
Symptoms of P2702
- Harsh or delayed shifts on gears using clutch C
- Vehicle may not shift out of Park on some Ford 8F35 units
- Wrench or engine warning light on
Common causes of P2702
- Most likelySticking valves in the main control valve body
- PossibleWorn clutch C plates or leaking piston seals
- PossibleLow or contaminated transmission fluid
- Less likelyOutdated transmission software or lost adaptive values
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Friction element cHydraulic control unitPressure control solenoid
What each part of P2702 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 7 | Area: transmission. |
| 02 | The exact fault in that area. |
What to do next
- Note P2702 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2702
What does P2702 mean?
P2702 means "Transmission Friction Element C Apply Time Range/Performance". With P2702 the transmission controller reports that friction element C does not engage within the time it expects, measured from the shift command to the moment the speed ratio changes. It is a generic code, so it means the same on every make.
Is it safe to drive with P2702?
Drive gently and only to a workshop. With P2702 the car can go into limp mode (reduced power) to protect itself.
Will P2702 fail an emissions test?
Yes, it can. P2702 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P2702 to fix?
Difficulty: workshop only. A typical repair takes 1 to 12 hours of work. This is a job for a workshop.
Will P2702 clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.