P2760 code meaning
Torque Converter Clutch Pressure Control Solenoid Control Circuit Intermittent
Powertrain system Generic code P27xx codes Check engine light
What P2760 means
P2760 records a converter clutch control circuit that drops out now and then and recovers by itself. Ford names it in its 2024 OBD summary as the circuit-intermittent result of the TCC solenoid, written as P0740 with failure byte 1F; its electrical check compares the driver feedback with the commanded state and reacts when they disagree for 1.5 seconds. Because the fault comes and goes, a static measurement in the workshop often finds nothing, and the freeze-frame data is the best clue. Loose terminals at the transmission case connector, a wire rubbing on a bracket or moisture that only causes trouble when hot are the classic causes. The driver may notice lockup cutting in and out, felt as a brief rpm flare at cruise.
P2760 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyMedium
- Typical labor0.5 to 4 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P2760
- Lockup drops out briefly, felt as an rpm flare
- Fault not reproducible in the workshop
- Warning lamp may come and go
Common causes of P2760
- Most likelyLoose or spread terminal at the case connector
- PossibleWire chafing intermittently against a bracket
- PossibleMoisture or heat-related contact fault
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Tcc pressure solenoidWiring harness
What each part of P2760 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 7 | Area: transmission. |
| 60 | The exact fault in that area. |
What to do next
- Note P2760 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2760
What does P2760 mean?
P2760 means "Torque Converter Clutch Pressure Control Solenoid Control Circuit Intermittent". P2760 records a converter clutch control circuit that drops out now and then and recovers by itself. It is a generic code, so it means the same on every make.
Is it safe to drive with P2760?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P2760 fail an emissions test?
Yes, it can. P2760 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P2760 to fix?
Difficulty: medium. A typical repair takes 0.5 to 4 hours of work. This is a job for a workshop.
Will P2760 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.