P2761 code meaning
Torque Converter Clutch Pressure Control Solenoid Control Circuit/Open
Powertrain system Generic code P27xx codes Check engine light
What P2761 means
P2761 says the TCM has lost continuity to the converter clutch pressure solenoid. GM documents the check in its six-speed TCM tables (16OBDG08 for the MW7 unit in Silverado/Sierra, 18OBDG04 for the T87A): with the driver switched off, an impedance of 173 kΩ or more counts as open, while 9.6 kΩ or less does not; after three hardware counts an intrusive test opens the low-side driver, and two confirming counts set the Type B code. The same tables block the stuck-off test P0741 while P2761 is pending. On 2023 Ram heavy-duty trucks with the 6.7 l Cummins, bulletin 1807223 lists P2761 among codes caused by a leaking capacitor inside the engine controller, so the solenoid is not always to blame.
P2761 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modeNot expected
- Repair difficultyMedium
- Typical labor0.5 to 5 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P2761
- No torque converter lockup
- MIL on after two trips (GM Type B)
- Higher cruise rpm and fuel use
Common causes of P2761
- Most likelyBroken wire or backed-out pin to the solenoid
- PossibleOpen solenoid winding
- Less likelyInternal controller fault (Ram 6.7 l ECM capacitor leak)
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Tcc pressure solenoidWiring harness
What each part of P2761 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 7 | Area: transmission. |
| 61 | The exact fault in that area. |
What to do next
- Note P2761 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2761
What does P2761 mean?
P2761 means "Torque Converter Clutch Pressure Control Solenoid Control Circuit/Open". P2761 says the TCM has lost continuity to the converter clutch pressure solenoid. It is a generic code, so it means the same on every make.
Is it safe to drive with P2761?
Usually yes, for a short time, if the check engine light is steady and the car drives normally. If the light flashes or the car runs badly, stop and have it checked.
Will P2761 fail an emissions test?
Yes, it can. P2761 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P2761 to fix?
Difficulty: medium. A typical repair takes 0.5 to 5 hours of work. This is a job for a workshop.
Will P2761 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.