P2763 code meaning
Torque Converter Clutch Pressure Control Solenoid Control Circuit High
Powertrain system Generic code P27xx codes Check engine light
What P2763 means
P2763 means the control circuit of the lockup pressure solenoid reads high. GM's 2018 T87A table treats it as a short to power, at 1.16 Ω or less to a voltage source while the driver is on, Type B. Its 2016 tables add variants: on the T76 six-speed the high-voltage flag also covers an open circuit and must persist 4.4 of 5 seconds over two trips; on the T54 CVT the module sets it when at least 750 mA is commanded but 200 mA or less flows for over 5 seconds. Subaru cites P2763 in bulletin 16-149-25 for the TR580 CVT in 2020–2023 Legacy, Outback, Crosstrek and Forester Wilderness: condensation can wet the valve-body connector, cured with a redesigned control valve plus connector cover. Ford's 2012 6R80 also files TCC driver faults here.
P2763 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium
- Typical labor0.5 to 5 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P2763
- No converter lockup, higher cruise rpm
- Transmission warning and MIL
- Other solenoid high codes at the same time (Subaru)
Common causes of P2763
- Most likelyMoisture in the valve-body connector (Subaru TR580)
- PossibleControl wire shorted to battery voltage
- PossibleOpen circuit where the maker includes it in this code (GM T76/T54)
- Less likelyFaulty TCM output stage
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Tcc pressure solenoidWiring harness
What each part of P2763 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 7 | Area: transmission. |
| 63 | The exact fault in that area. |
What to do next
- Note P2763 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2763
What does P2763 mean?
P2763 means "Torque Converter Clutch Pressure Control Solenoid Control Circuit High". P2763 means the control circuit of the lockup pressure solenoid reads high. It is a generic code, so it means the same on every make.
Is it safe to drive with P2763?
Drive gently and only to a workshop. With P2763 the car can go into limp mode (reduced power) to protect itself.
Will P2763 fail an emissions test?
Yes, it can. P2763 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P2763 to fix?
Difficulty: medium. A typical repair takes 0.5 to 5 hours of work. This is a job for a workshop.
Will P2763 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.