P076A code meaning
Shift Solenoid H
Powertrain system Generic code P07xx codes Check engine light
What P076A means
Shift solenoid H exists only on transmissions with eight or more solenoids. Ford's 10R80 ends at F, GM's 9- and 10-speeds report clutch pressure valve codes; the only documented user of the H block is the 2017–18 Genesis G80/G90 with shift-by-wire, where it concerns the on/off solenoid of the park lock rather than a shift valve. Hyundai's bulletins name P076A both 'SBW park system fault' and 'on/off solenoid C (park – SBW)'. The remedy is replacing valve and electronic module or the park position switch and actuator, then the transmission module if the code returns. No other manufacturer uses P076A.
P076A at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium
- Typical labor1 to 4 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P076A
- Check engine light
- Park lock or range selection fault, shift-by-wire warning
- Limp mode
Common causes of P076A
- Most likelyPark lock on/off solenoid or electronic module faulty
- PossiblePark position switch or actuator (shift-by-wire)
- PossibleConnector or wiring
- Less likelyTransmission module
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Park lock solenoidPark position switchTransmission electronic moduleTransmission control module
What each part of P076A means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 7 | Area: transmission. |
| 6A | The exact fault in that area. |
What to do next
- Note P076A and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P076A
What does P076A mean?
P076A means "Shift Solenoid H". Shift solenoid H exists only on transmissions with eight or more solenoids. It is a generic code, so it means the same on every make.
Is it safe to drive with P076A?
Drive gently and only to a workshop. With P076A the car can go into limp mode (reduced power) to protect itself.
Will P076A fail an emissions test?
Yes, it can. P076A is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P076A to fix?
Difficulty: medium. A typical repair takes 1 to 4 hours of work. This is a job for a workshop.
Will P076A clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.