P076B code meaning
Shift Solenoid H Performance/Stuck Off
Powertrain system Generic code P07xx codes Check engine light
What P076B means
Shift solenoid H exists only on transmissions with eight or more solenoids. Ford's 10R80 ends at F, GM's 9- and 10-speeds report clutch pressure valve codes; the only documented user of the H block is the 2017–18 Genesis G80/G90 with shift-by-wire, where it concerns the on/off solenoid of the park lock rather than a shift valve. P076B means solenoid H is commanded on but does not take effect, like P0761 for solenoid C. No manufacturer document available to us uses this code; Hyundai uses only P076A and P076D. The description follows the scheme for the other solenoids.
P076B at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyHard
- Typical labor1.5 to 12 hours
- Clears after repairAfter a drive cycle
Symptoms of P076B
- Gears missing or skipped
- Slip or engine flare on shifts
- Limp mode
- Check engine light
Common causes of P076B
- Most likelyClutch or brake of this circuit leaking or worn (piston seal, linings)
- PossibleShift spool or proportional valve sticking (dirt, debris)
- PossibleFluid level or quality
- Less likelyPressure switch faulty (Allison, Aisin)
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Shift solenoidTransmission valve bodyTransmission wiringTransmission control module
What each part of P076B means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 7 | Area: transmission. |
| 6B | The exact fault in that area. |
What to do next
- Note P076B and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P076B
What does P076B mean?
P076B means "Shift Solenoid H Performance/Stuck Off". Shift solenoid H exists only on transmissions with eight or more solenoids. It is a generic code, so it means the same on every make.
Is it safe to drive with P076B?
Drive gently and only to a workshop. With P076B the car can go into limp mode (reduced power) to protect itself.
Will P076B fail an emissions test?
Yes, it can. P076B is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P076B to fix?
Difficulty: hard. A typical repair takes 1.5 to 12 hours of work. This is a job for a workshop.
Will P076B clear itself after the repair?
After the repair the car has to complete a drive cycle (a mix of city and highway driving) before the test runs again. Until then the readiness monitor shows "not ready", which can fail an inspection.