P095A code meaning
Gear Shift Position Circuit C
Powertrain system Generic code P09xx codes Check engine light
What P095A means
Circuit C is a third channel reporting the shift position inside an automated manual gearbox, for example a further sensor track or a sensor on another shift rail or selector shaft. This general circuit code sets on an electrical fault of that signal that fits none of the more specific C variants. No manufacturer documents the code publicly, and which sensor carries the letter C depends on the design. A Nissan/Aichi patent describes shift stroke sensors as the feedback for engaging gears, an Aisin AI patent the fallback when a stroke sensor fails. CARB requires circuit checks on such inputs. P095B to P095D are the C siblings, P0914 and P091A the same signal on circuits A and B. Shifting may be restricted.
P095A at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyHard
- Typical labor0.5 to 4 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P095A
- Transmission or engine warning light on
- Slower or restricted gear changes in fallback mode
- Gearbox may hold a gear or stay in neutral
Common causes of P095A
- Most likelyLoose or corroded connector at shift position sensor C
- PossibleDamaged signal, supply or ground wire of sensor circuit C
- PossibleFaulty shift position sensor C
- Less likelyFaulty sensor input in the transmission control module
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Gear shift position sensor cWiring harnessTCM
What each part of P095A means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 0 | Generic code: it means the same on every make (SAE standard). |
| 9 | Area: transmission. |
| 5A | The exact fault in that area. |
What to do next
- Note P095A and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P095A
What does P095A mean?
P095A means "Gear Shift Position Circuit C". Circuit C is a third channel reporting the shift position inside an automated manual gearbox, for example a further sensor track or a sensor on another shift rail or selector shaft. It is a generic code, so it means the same on every make.
Is it safe to drive with P095A?
Drive gently and only to a workshop. With P095A the car can go into limp mode (reduced power) to protect itself.
Will P095A fail an emissions test?
Yes, it can. P095A is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P095A to fix?
Difficulty: hard. A typical repair takes 0.5 to 4 hours of work. This is a job for a workshop.
Will P095A clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.