P267A code meaning
"B" Rocker Arm Actuator Position Sensor Circuit (Bank 2)
Powertrain system Generic code P26xx codes Check engine light
What P267A means
Continuously variable lift systems turn a control or eccentric shaft with an electric motor and report the shaft angle back to the engine controller. On V engines each cylinder bank has its own mechanism; Nissan's VVEL on the VQ37VHR V6 and VK50VE V8 is an example of such a two-bank layout. P267A is the unspecific circuit fault of feedback sensor B on bank 2: the signal is unusable, but the controller does not classify it as too low or too high. No manufacturer documents P267A publicly; Toyota's bulletins use the B sensor letter only for its inline Valvematic engines and code P265B. CARB requires electrical checks on every input of a lift system. Expect connector, supply or ground problems first; P267B to P267E name more specific failure patterns.
P267A at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyHard
- Typical labor0.5 to 4 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P267A
- Check engine light on
- Variable lift on bank 2 held at a fixed default
- Reduced power or rough idle
Common causes of P267A
- Most likelyLoose, corroded or damaged plug at the bank 2 position sensor
- PossibleBroken or chafed signal, reference or ground wire
- PossibleInternal fault of position sensor B, bank 2
- Less likelyFault in the engine or lift control module input
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Rocker arm position sensor b b2Wiring harness
What each part of P267A means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 6 | Area: computer (engine control module) and output circuits. |
| 7A | The exact fault in that area. |
What to do next
- Note P267A and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P267A
What does P267A mean?
P267A means ""B" Rocker Arm Actuator Position Sensor Circuit (Bank 2)". Continuously variable lift systems turn a control or eccentric shaft with an electric motor and report the shaft angle back to the engine controller. It is a generic code, so it means the same on every make.
Is it safe to drive with P267A?
Drive gently and only to a workshop. With P267A the car can go into limp mode (reduced power) to protect itself.
Will P267A fail an emissions test?
Yes, it can. P267A is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P267A to fix?
Difficulty: hard. A typical repair takes 0.5 to 4 hours of work. This is a job for a workshop.
Will P267A clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.