P267D code meaning
"B" Rocker Arm Actuator Position Sensor Circuit High (Bank 2)
Powertrain system Generic code P26xx codes Check engine light
What P267D means
P267D is stored when the angle feedback of lift actuator B on bank 2 rises above its upper valid limit. Typical causes are an open sensor ground, which lets the signal float toward the reference, a signal conductor touching a supply line, or water bridging contacts in the connector. Systems such as BMW's Valvetronic, where an electric motor swings an eccentric shaft through a fixed arc, never place the sensor at the supply rail in normal operation, so such a value is rejected. No manufacturer documents P267D publicly; detection follows from CARB's input checks for variable lift. The controller holds bank 2 at a safe setting. Measure ground continuity first. Low-side partner: P267C; dropouts: P267E.
P267D at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyHard
- Typical labor0.5 to 4 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P267D
- Check engine light on
- Reduced power with lift fixed on bank 2
- Slightly higher fuel consumption
Common causes of P267D
- Most likelyOpen or high-resistance ground of the position sensor
- PossibleSignal wire shorted to reference or battery voltage
- PossibleMoisture or corrosion bridging pins in the sensor plug
- Less likelyDefective position sensor B, bank 2
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Rocker arm position sensor b b2Wiring harness
What each part of P267D means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 6 | Area: computer (engine control module) and output circuits. |
| 7D | The exact fault in that area. |
What to do next
- Note P267D and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P267D
What does P267D mean?
P267D means ""B" Rocker Arm Actuator Position Sensor Circuit High (Bank 2)". P267D is stored when the angle feedback of lift actuator B on bank 2 rises above its upper valid limit. It is a generic code, so it means the same on every make.
Is it safe to drive with P267D?
Drive gently and only to a workshop. With P267D the car can go into limp mode (reduced power) to protect itself.
Will P267D fail an emissions test?
Yes, it can. P267D is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P267D to fix?
Difficulty: hard. A typical repair takes 0.5 to 4 hours of work. This is a job for a workshop.
Will P267D clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.