P267E code meaning
"B" Rocker Arm Actuator Position Sensor Circuit Intermittent/Erratic (Bank 2)
Powertrain system Generic code P26xx codes Check engine light
What P267E means
Here the bank 2 angle signal of lift actuator B is mostly plausible, yet it drops out for moments or jumps by amounts the motor-driven shaft could not cover in the time between two readings. The engine controller counts such events and sets P267E once they exceed its tolerance. Loose terminals, a wire cracked inside its insulation near the cylinder head, and interference from ignition or actuator wiring are the usual suspects; the fault often depends on heat or vibration. No manufacturer documents P267E publicly. CARB asks lift system inputs to be checked for signal quality, not only for fixed limits. While the reading jumps, lift control on bank 2 can hunt or be parked. Recording the signal while moving the harness helps locate the fault.
P267E at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyHard
- Typical labor0.5 to 4 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P267E
- Check engine light that may come and go
- Brief hesitation or surging
- Uneven running when lift control on bank 2 hunts
Common causes of P267E
- Most likelyLoose or fretted terminal in the sensor connector
- PossibleWire broken inside insulation, opening under heat or vibration
- Less likelyInterference from nearby ignition or actuator wiring
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Rocker arm position sensor b b2Wiring harness
What each part of P267E means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 6 | Area: computer (engine control module) and output circuits. |
| 7E | The exact fault in that area. |
What to do next
- Note P267E and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P267E
What does P267E mean?
P267E means ""B" Rocker Arm Actuator Position Sensor Circuit Intermittent/Erratic (Bank 2)". Here the bank 2 angle signal of lift actuator B is mostly plausible, yet it drops out for moments or jumps by amounts the motor-driven shaft could not cover in the time between two readings. It is a generic code, so it means the same on every make.
Is it safe to drive with P267E?
Drive gently and only to a workshop. With P267E the car can go into limp mode (reduced power) to protect itself.
Will P267E fail an emissions test?
Yes, it can. P267E is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P267E to fix?
Difficulty: hard. A typical repair takes 0.5 to 4 hours of work. This is a job for a workshop.
Will P267E clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.