P2717 code meaning
Pressure Control Solenoid D Intermittent
Powertrain system Generic code P27xx codes Check engine light
What P2717 means
P2717 reports that the circuit or response of solenoid D drops out briefly and then comes back. Unlike a hard open or short, the fault is gone by the time the vehicle reaches the workshop, so a static measurement often looks fine. No manufacturer documents P2717 publicly. Ford shows the principle on its shift solenoids: the 2024 OBD summary attaches failure byte 1F (circuit intermittent) to the base code, and P2710 is the counterpart for shift solenoid F. Under CARB rules a solenoid circuit must be watched continuously. Typical triggers are spread terminals, a wire rubbing through near the valve body, or moisture in the connector, and the fault often appears only when hot or on rough roads. The gearbox may stay in a substitute mode until the engine is restarted.
P2717 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium
- Typical labor0.5 to 4 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P2717
- Occasional harsh or flared shift
- MIL that comes and goes
- No fault found during a workshop check
Common causes of P2717
- Most likelySpread or loose terminal at transmission or TCM connector
- PossibleWire rubbing through intermittently
- PossibleMoisture or corrosion in the connector
- Less likelyHeat-dependent break inside the coil
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Pressure control solenoid dWiring harness
What each part of P2717 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 7 | Area: transmission. |
| 17 | The exact fault in that area. |
What to do next
- Note P2717 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2717
What does P2717 mean?
P2717 means "Pressure Control Solenoid D Intermittent". P2717 reports that the circuit or response of solenoid D drops out briefly and then comes back. It is a generic code, so it means the same on every make.
Is it safe to drive with P2717?
Drive gently and only to a workshop. With P2717 the car can go into limp mode (reduced power) to protect itself.
Will P2717 fail an emissions test?
Yes, it can. P2717 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P2717 to fix?
Difficulty: medium. A typical repair takes 0.5 to 4 hours of work. This is a job for a workshop.
Will P2717 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.