P2716 code meaning
Pressure Control Solenoid D Electrical
Powertrain system Generic code P27xx codes Check engine light
What P2716 means
P2716 is the general electrical code for pressure control solenoid D: the output stage sees a wrong current or voltage on the coil, without saying whether the circuit is open, grounded or shorted to supply. No manufacturer documents P2716 publicly. The makers that publish data on valve D split its electrical checks instead: GM's 2016 eight-speed table uses P2718, P2720 and P2721 with 0.3 s fail times, and Ford's 2024 summary gives the same three codes for open load, shorted switch and shorted load. CARB requires the circuits of transmission solenoids to be monitored as comprehensive components. When a controller does use this broad code, the cause is usually a coil, a connector or the harness, and the gearbox drops into a fail-safe mode with fixed gears.
P2716 at a glance
- Check engine lightYes, usually on
- Emissions testCan fail
- Limp modePossible
- Repair difficultyMedium
- Typical labor0.5 to 5 hours
- Clears after repairWhen cleared with a scanner
Symptoms of P2716
- MIL lit and transmission in fail-safe mode
- Fixed gear or missing gears
- Harsh engagement after start
Common causes of P2716
- Most likelyOpen or shorted coil in solenoid D
- PossibleLoose, corroded or not fully seated connector
- PossibleChafed internal or external harness
- Less likelyFaulty driver stage in the TCM
Check the most likely causes first. Replacing parts by guesswork is the most expensive way to clear a code.
Parts involved
Pressure control solenoid dWiring harness
What each part of P2716 means
| P | Powertrain system: engine, fuel system, ignition, emissions and transmission. |
| 2 | Generic code (second SAE range): it means the same on every make. |
| 7 | Area: transmission. |
| 16 | The exact fault in that area. |
What to do next
- Note P2716 and any other codes stored with it: several codes together often point to one cause.
- Check for loose connectors and damaged wiring around the parts the code names.
- Check open recalls for your car: some faults are fixed for free by the dealer. Enter your VIN.
- Clear the code only after the repair. If it comes back, the fault is still there.
Buying a used car? Scan it for stored codes before you pay. A recently cleared memory can hide a problem.
Questions about P2716
What does P2716 mean?
P2716 means "Pressure Control Solenoid D Electrical". P2716 is the general electrical code for pressure control solenoid D: the output stage sees a wrong current or voltage on the coil, without saying whether the circuit is open, grounded or shorted to supply. It is a generic code, so it means the same on every make.
Is it safe to drive with P2716?
Drive gently and only to a workshop. With P2716 the car can go into limp mode (reduced power) to protect itself.
Will P2716 fail an emissions test?
Yes, it can. P2716 is emissions-related, so most inspection programs fail a car while it is stored or while the check engine light is on.
How hard is P2716 to fix?
Difficulty: medium. A typical repair takes 0.5 to 5 hours of work. This is a job for a workshop.
Will P2716 clear itself after the repair?
Clear the code with a scanner after the repair. If the fault is fixed, it does not come back.